Machine Vise VarioLine VL160

The ROEMHELD Machine Vise Varioline comes in a mechanical-hydraulic design for manual operation or a hydraulic design for use in semi or fully automatic operation. The clamping force can be applied manually using a crank handle (mechanical-hydraulic design)
or by means of a hand or footswitch (hydraulic design). The use of a pressure gauge (an optional extra) permits exact, continuous clamping force display and exact clamping force monitoring. The vise is compatible with ROEMHELD’s standard jaws, as well as customer’s existing special jaws. Available in the three sizes shown below, with the following jaw widths: 100mm, 125mm, and 160mm.

max. clamping force:
VL 100 M: 25 kN
VL 125 M: 40 kN
VL 160 M: 50 kN
VL 100 H: 25 kN at 350 bar
VL 125 H: 40 kN at 350 bar
VL 160 H: 60 kN at 350 bar

Mechanical-hydraulic design, manual operation
The completely revised force transmission requires minimum effort on the crank handle. An angle drive (optional extra)
facilitates the operation, e.g. in the case of longitudinal clamping on the machine table. The optional
clamping force preselection (retrofittable) enables the force to be applied in 6 stages up to the maximum.

Hydraulic design, for use in semi or fully automatic operation
Connection to a separate hydraulic pressure transducer, e.g. a hydraulic power unit. Coarse adjustment of the clamping
range using socket pins. Precise positioning against the workpiece and adjustment of the insertion tolerance
manually using lead screw. The clamping process is triggered by a hand or foot switch in the case of fully automatic
working cycle.